Pictograms; Transport; Machine Components - Sima DUPLO Manual De Instrucciones Original

2.1 PICTOGRAMS

Pictograms included in the machine entail the following:
READ INSTRUCTIONS
MANUAL
USE SAFETY GLOVES

3. TRANSPORT

For safe transport, we strongly recommend to read the following instructions:
When it is needed to transport the machine for too long distances by vehicles, cranes or other means of
elevation, the latter should be safe.
By lifting the machine with cranes or hoists, normalised slings must be used. These are chosen en function of
the required work load limit, the way of use and the nature of the load. The choice is correct if special norms of use
are respected.
DUPLO models have a hook A, Fig.2 that allows easily perform this operation.
There is also a OPTIONAL transport truck that allow their displacement manually by a single operator. Fig 3.
To transport the machine with optional truck, enter the truck until the wheels may remain in the middle point of the
machine, raise the handlebars upward position 1, Fig.3 and make the link between machine and truck through the
links arranged in both sides, then lower the handle to position 3, Fig.3 and then perform the coupling of the truck with
the machine by inserting the pin A, Fig.3. this way the machine will have been suspended on her transport truck to be
moved
ATTENTION: To avoid any possible danger, stay away from elevated loads and be careful with their possible
displacement during transport, whether during lifting or mooring. Therefore, it is essential to choose the correct slings
and remain particularly vigilant in sensitive operations (elevation, coupling, mooring or discharging).
WARNING: During transportation of the machine is never to be reversed nor support on either side, must be
supported by its base.

4. MACHINE COMPONENTS

See Figure 5 for the components of the machine.
1 Battery.
2 Fuel tank
3. Steering wheel regulation tilt paddles.
4 CONTROLS safety stop.
5 Remote control driving.
6 Push button to pump water removal.
7 Driver's Seat
8 Transmission protection.
9. Front headlight (connects via switch next to the key motor connection)
10 Handle adjustment of the seat.
11 Rear headlight (connects via switch next to the key motor connection)
12 Deposi of water.
13 Accelerator pedal .
14 Blades
USE HELMET AND EYE AND
AUDITIVE PROTECTION
USE SAFETY BOOTS
-6-
ENGLISH