Special Safety Precautions For This Device; General Operation - AEG BSS 4813 Instrucciones De Servicio

6 MO/ST button (Mono/Stereo)
7 SLEEP button (sleep timer)
8 CLOCK button (clock settings)
9 / TUNING buttons (scan forward/back)
10 VOL+/VOL- buttons (volume)
11 TREBLE buttons (treble settings)
12 BASS buttons (bass settings)
13 Number buttons
14 MEM button

Special Safety Precautions for this device

WARNING:
Avoid hearing loss due to extreme volume.
CAUTION:
• Do not subject the speakers to extreme heat, cold or
humidity.
• Do not operate the device on maximum volume. This
can cause damage.
• Do not touch the speaker membranes with fingers or
objects. This will cause damage to the membranes.
First Use of the Device/Introduction
NOTE:
Some buttons can be found both on the device and on the
remote control. Identical buttons perform the same func-
tion.
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Insert/Replace Battery in Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control may have been safeguarded for transport with a
piece of foil. This extends the life of the battery. Please
remove this foil before the first use to make the remote
control ready for operation.
• Open the battery compartment on the underside of the
remote.
• Replace the cell by a battery of the same type (CR 2025).
Check that the polarity is correct (see battery compart-
ment).
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• Do not expose the batteries to intense heat, such as
sunlight, fire or similar. Danger of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
Batteries must not be disposed of in the garbage. Please
bring used batteries to competent collection centers or
back to the dealer.
Restoring the factory defaults
Any errors during operation can be remedied by pushing the
reset button.
• By using a wire or similar, press the reset button (RESET)
on the back of the device to reset the electronics. The
settings made by you will be lost in the process.
Setting the clock
1. During standby mode, press and hold the CLOCK but-
ton (8 on the remote control) for approx. 3 seconds. The
display will show "CLK" and the currently set time. The
hour setting will flash.
2. Use the / TUNING buttons (9 on the remote control)
to adjust the hours.
3. Press the CLOCK button. The minutes will start flashing.
4. Use the / TUNING buttons to adjust the minutes.
5. Press the CLOCK button again. The notification "CLK"
disappears and the time setting will be saved.

General Operation

Switch device on/off
• With the button (3/4), you can switch the unit between
standby and operating mode. During standby mode, the
time will be shown in the display.
English
35