Connection Screen; Range Of Radio Signal; Connected Operation - Nelson EZ 8600 Guía De Instalación Y Programación

EZ PRO RADIO SETUP

Connection Screen

When connected, the Radio Connected
display will show the current status of the EZ Pro. The LCD screen will display the EZ Pro's Mode Dial position (Auto,
Program, or Off) and Program Dial position (A, B, or C). If there are any zone problem messages these will be displayed on
the LCD. If there is a Rain Delay Programmed or the Rain Sensor is activated these will be displayed.
The EZ Command LCD will display all programming or operation commands exactly as seen on the EZ Pro controller. This
instant feedback assures that the EZ Pro controller retains any changes you make.
While radio connected, the EZ Command will temporarily override dial settings and status of the EZ Pro. All manual and
programming functions of the EZ Pro can be controlled from the EZ Command Remote Programmer.

Range of Radio Signal

Radio signal range is greatest when there is a clear line of sight between the EZ Pro and the EZ Command. The type and
size of structure that the EZ Pro is located in as well as the local terrain may effect performance.

Connected Operation

After one minute of use without a dial turn or a button press, the EZ Command will enter a "sleep" mode. This is to extend
battery life.
The unit will "wake" once a minute and update the LCD screen.
Pressing any button or turning the dial will also "wake" the EZ Command.
After 15 minutes of non-use the radio connection will stop and the EZ Command will turn off. You will need to connect to the
EZ Pro again.
symbol will show on both the EZ Command unit and on the EZ Pro. The LCD
7