Programming And Operating Instructions; Disconnecting From The Ez Pro; Care Of The Ez Command - Nelson EZ 8600 Guía De Instalación Y Programación

PROGRAMMING AND OPERATING INSTRUCTIONS

While radio connected use the Large dial, SELECT buttons, ADJUST buttons, A,B,C button and the AUTO, PROG, OFF button
on the EZ Command to program and operate the EZ Pro controller as desired. See the EZ Pro Instruction book for all
programming and operating instructions.
NOTE: Program changes made while radio connected are retained by the EZ Pro.

Disconnecting from the EZ PRO

To disconnect from the EZ Pro press the Radio On/Off key. The radio will disconnect and the EZ Command unit will turn off.
Once disconnected the EZ Pro will return to the previous status. Any program changes made will be saved in the EZ Pro.
NOTE: A manual zone run, a Cycle, or a 3 Minute Test started by the EZ Command will continue after the radio is
disconnected. The EZ Pro will return to its previous status after the operation is finished.

Care of the EZ Command

Avoid letting the EZ Command get wet. While it is water-resistant it is not waterproof. Water inside the unit will damage the
circuitry. Do not drop the EZ Command. This may damage the unit.
8