Drain Piping - Hitachi YUTAKI Serie Manual De Instrucciones

DrAIn PIPInG

9 DRAIN PIPING
9.1 DRAIN DISCHARGING BOSS
When the base of the outdoor unit is temporarily utilized as a
drain receiver and the drain water in it is discharged, this drain
boss is utilized to connect the drain piping.

Connecting procedure
1 Insert the rubber cap into the drain boss up to the extruded
portions.
2 Insert the boss into the unit base and turn approximately 40
degree counterclockwise.
3 Size of the drain boss is 32 mm (o.D.).
4 A drain pipe should be field-supplied.
N O T E
• Do not use this drain boss set in a cold area, because the drain water
may freeze.
• This drain boss is not sufficient to collect all the drain water. If
collecting drain water is completely required, provide a drain-pan that
is bigger than the unit base and install it under the unit with drainage.
12 PMML0372B rev.1 - 03/2016
Model Applicable Model
DBS-26 All units
Drain pipe
Drain pipe
Extruded portion
Drain Boss
rubber cap
Drain hole
of Base