Measuring Depth (Sonde Mode); Clipping (Sonde Mode); Menus And Settings - RIDGID SeekTech SR-20 Manual Del Usuario

Measuring Depth (Sonde Mode)

The SR-20 calculates Measured Depth by comparing the
strength of the signal at the lower antenna to the upper
antenna. Measured Depth is approximate; it will usu-
ally reflect the physical depth when the mast is held
vertical and the bottom antenna is touching the ground di-
rectly above the signal source, assuming no distortion is
present.
1. To measure depth, place the locator on the ground,
directly above the Sonde or the line.
2. Measured Depth will be shown in the lower left
hand corner of the SR-20's display screen.
3. A Measured Depth reading can be forced by press-
ing the Select Key during a locate.
4. Measured Depth will be accurate only if the signal is
undistorted.

Clipping (Sonde Mode)

Occasionally the Signal Strength will be strong enough
that the receiver will be unable to process the entire sig-
nal, a condition known as "clipping". When this occurs,
a warning symbol will appear on the screen. It means
that the signal is particularly strong.
NOTE! Measured Depth Display is disabled under clip-
ping conditions.

Menus and Settings

Pressing the Menu Key brings up a series of choices
which let the operator configure the SR-20 as preferred
(See Figure 33).
Auto Menu Exit
Countdown
Timer
Figure 32 – Main Menu
In sequence from the top of the menu down, the Main
Menu presents the following items:
1. Currently Available Sonde frequencies
(Checked - Active or not).
2. Currently Available Active Line Trace fre-
quencies (Checked-Active or not).
3. Currently Available Passive Line Trace fre-
quencies (Checked-Active or not).
4. Currently Available Radio Frequencies (Low
and High) (Checked-Active or not).
5. Depth Measurement Units Setting
6. Backlight Control.
7. LCD Contrast Control
8.
display when selected for Sonde or line tracing
modes.)
9.
will display for categories of frequencies that can be
selected.)
10. Information Menu including software version
and unit serial number (sub-menu for restoring fac-
tory defaults will display on Information screen).
See the Menu Tree on page 27 for a complete list.
Auto Menu Exit Count-down Timer
While traversing the menu tree, a counter appears at
the bottom of the screen counting down. When it reaches
zero, it will automatically move back up one level of the
menu tree until it reaches the operating screen again. It re-
sets to nine with each key press, or each time it goes up
one menu level, until it reaches the operating screen.
Currently Available Sonde
Frequencies
Frequencies that have been set to "Checked-Active" sta-
tus appear with a check box next to them. If the checkbox
is checked, the frequency can be accessed using the
Frequency Key. Frequencies are checked or unchecked
by highlighting them and pressing the Select Key. To
return to the operating screen, press the Menu Key.
Possible included frequencies are:
16 Hz
850 Hz
33 kHz
* = Set to "Currently Available" by default.
Ridge Tool Company
SeekTech SR-20
Display Elements Control (Submenus will
Frequency Selection Control (Sub-menus
512 Hz* 640 Hz
8 kHz 16 kHz
21