Troubleshooting Guide - KNOVA KN BTS-10N Manual De Uso

TROUBLESHOOTING GUIDE

CAU TION
To avoid injury from accidental starting, always turn the switch OFF and unplug the tool before moving,
replacing the blade or making adjustments. If for any reason the motor will not run, consult customer service at
01-800-70-KNOVA (56682)
PR OBL EM
Saw will not start.
Does not make accurate
45° and 90° rip cuts.
Material pinched
blade when ripping.
Material binds
on riving knife.
Saw makes
unsatisfactory cuts.
Material kicked
back from blade.
Blade does not
raise or tilt freely.
Blade does not come
up to speed. Reset
trips too easily.
Machine vibrates
excessively.
Does not make accurate
45° and 90° crosscuts.
P O S S IB LE C AU S E S
1. Saw not plugged in.
2. Fuse blown or circuit breaker
tripped.
3. Cord damaged.
4. Debris in on/off switch.
1. Positive stop not adjusted
correctly.
2. Tilt angle pointer not set
accurately.
1. Rip fence not aligned with blade.
2. Warped wood, edge against
fence is not straight.
1. Riving knife not aligned
correctly with blade.
1. Dull blade.
2. Blade mounted backwards.
3. Gum or pitch on blade.
4. Incorrect blade for work
being done.
5. Gum or pitch on blade causing
erratic feed.
1. Rip fence out of adjustment.
2. Riving knife not aligned with blade.
3. Feeding stock without rip fence.
4. Riving knife not in place.
5. Dull blade.
6. The operator letting go of material
before it is past saw blade.
7. Miter angle lock knob is not tight.
1. Sawdust and dirt in
elevation/tilting mechanisms.
1. Extension cord too light
or too long.
2. Low house voltage.
1. Saw not mounted securely
to workbench.
2. Bench on uneven floor.
3. Damaged saw blade.
1. Miter gauge out of adjustment.
CORREC TIVE ACTION
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Replace power cord.
4. Remove switch from saw and separate in
half. Clean any debris accumulated within.
1. Check blade with square and adjust
positive stop.
2. Check blade with square and adjust to zero.
1. Check and adjust rip fence.
2. Select another piece of wood.
1. Check and align riving knife with blade.
1. Replace blade.
2. Turn the blade around.
3. Remove blade and clean with turpentine
and coarse steel wool.
4. Change the blade.
5. Clean table with turpentine and steel wool.
1. Align rip fence with miter gauge slot.
2. Align riving knife with blade.
3. Install and use rip fence.
4. Install and use splitter. (with guard).
5. Replace blade.
6. Push material all the way past saw
blade before releasing work.
7. Tighten knob.
1. Brush or blow out loose dust and dirt.
1. Replace with adequate size cord.
2. Contact your electric company.
1. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace blade.
1. Adjust miter gauge.
22