Installation; Unit Positioning; Installation Procedure - Ferroli JOLLY Plus 2 Serie Manual De Instalación

INSTALLATION

Unit positioning

Avoid installing the unit near:
- places subject to exposure to direct sunlight;
- in the vicinity of heat sources;
- in damp places and areas with likely contact with water;
- in places with oil vapours
- in places subject to high frequencies .
Make sure:
- the wall where the unit is to be installed has an adequate structure and load bearing capacity;
- the part of the wall concerned is not crossed by pipes or power lines
- the wall concerned is perfectly flat;
- there is an area free from obstacles that could compromise the circulation of inlet and outlet air;
- the installation wall is possibly an outer wall to allow the condensate to be discharged outside;
- in case of ceiling installation, the air flow is not directly towards people.

Installation procedure

The following descriptions of the various installation phases and the relevant drawings refer to a version of the unit
with connections on the left . The descriptions for installation of units with connections on the right are the same . Only
the images are to be considered as represented specularly .
For best installation results and optimum performance, carefully follow the instructions given in this manual .
Failure to apply the regulations indicated, which can cause malfunction of the unit, relieves the manufacturer from
any form of guarantee and liability for damage to persons, animals or property .
The electrical system must be executed in compliance with the regulations, respecting the data given in the technical
sheet, and must have good earthing .
The unit must be installed in a place facilitating routine maintenance (filter cleaning) and extraordinary maintenance,
as well as access to air vent valves reachable from the upper grille, connections side .
8