Saci DRENOX 80/7 Manual De Uso página 7

The linear express measures in chart are in millimeters
TYPE
MIN. PRIMING
Picture
®
DRENOX 80/7
®
DRENOX 160/8
®
DRENOX 250/10
®
DRENOX 350/12
Pump with less than 10 mt. supply cord cannot be used in open spaces.
The min. priming level refers to completely submerged outlet. (See Pict. 1A-1B ref.A)
®
DRENOX 80/7 can drain water up to 3mm. from ground, once pump is priming . (See Pict. 1A ref.B)
CHAP. 3 INSTALLA TION
Please use handlebar to remove or lift pump up.
Please use a non-return valve in case pump is connected to fixed installation with rigid piping; this will avoid liquid circulating when
pump has been turned off; use of a pipe fitting will allow easy disconnection of pump for maintenance.
Dimensions of drain well must allow max. 30 on/off cycles/hour. ( See USE AND HIS LIMITATIONS )
Please use flexible pipe connected to pump by means of plastic fitting in case of temporary use of pump.
Use a rope to immerse pump and fasten it to pump's handlebar.
®
DRENOX is equipped with a pre-rated float switch ( See Pict. 1/A and 1/B ); please increase or decrease the free piece of float
switch cable by making it sliding through the proper seat on the handlebar, when modifying the rating of float switch.
Pumps used besides or inside swimming pools, garden ponds or similar places may have special requirements.
CHAP. 4 ELECTRIC CONNECTION
Single phase pumps are equipped with double ground contact plugs at top end of supply cord ; in this case grounding is done when
plugging in.
In this case the ground wire ( yellow-green cable ) of supply cord must be connected to ground wire of electric current network.
Ensure connection to electric current network by using an omnipolar-sectionned magneto thermic circuit-breaker.
This will ensure effective disconnection from electric current network.
MIN. DRAINAGE
LEVEL LEVEL
A B
80 mm 3 mm
96 mm 35 mm
96 mm 35 mm
96 mm 35 mm
DANGER
Electric shock risk
REMARK
REMARK
DANGER
REMARK
DANGER
Electric shock risk
DANGER
Electric shock risk
Single phase version
Three phase version
Please refer to Pict. 1A and Pict. 1B
START LEVEL STOP LEVEL
D
C
100 mm
250 mm
107 mm
320 mm
351 mm 111 mm
111 mm
351 mm
When installing, please ensure pump is disconnected
from electric current network.
Make sure that float switch turns off pump, when at min.
level of liquid.
Make sure no obstacles stand in the way of float switch,
during up/down swinging.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Ensure tension and frequency of pump ( read motor
plate ) and supply network are same.
Installer must make sure that electric current network
has ground wire conforming to current laws.
Make sure that electric current network is provided with a
high-sensitivity circuit-breaker
=30 mA (DIN VDE 0100T739)
GB
WEIGHT
Kg.
5,7
6,5
7
8,5
5