Maintenance And Cleaning - Miomare 296095 Instrucciones De Montaje, De Uso Y De Seguridad

Note: If you turn off the water flow using the control
lever then the fitting automatically switches to
6
bath filling.
Setting the temperature limiter
The cartridge in this unit has a temperature limiter.
11
This function is not activated in the factory (neutral
setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Turn off the main water supply.
Remove the red / blue hot / cold label
carefully by a small flat screwdriver (see Fig. D).
Release the locking screw
clockwise using a hexagon key
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
Take off the control lever
Loosen the cartridge end ring
screw off the cartridge locking ring
a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge.
Place the setting ring in the desired position as
shown in Fig. E.
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body again by using a pipe wrench,
4
then tighten the cartridge end ring
Place the control lever
body and tighten the locking screw
4
turning it clockwise using a hexagon socket screw
key .
13
Press the red / blue hot / cold label
opening.
Turn on the main water supply and check the
temperature limiter.
8
by turning it anti-
7
.
13
can
6
.
6
by hand, then
9
by using
10
upwards with the
12
can limit the turning
12
onto the
10
by hand.
9
back on to the tap
6
by
7
into the
8

Maintenance and cleaning

Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is wholly composed of environmen-
tally friendly materials that can be disposed of at a
local recycling centre.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
at regular intervals
4c
GB/MT 19