Error Messages - Ferroli VARESE Serie Manual Técnico Y De Instalacion

• Eco Mode: Economic mode with lower emissions and almost negligible noise level. ECO icon back lit in green
• Comfort mode: average emission mode, suitable for normal boiler ignition: COMFORT icon back lit in red
• Boost mode: high performance mode. The emitter is at its maximum capacity issue. Recommended for situations of extreme cold or ignition
after long periods of absence from the home. "Boost" icon backlit in red
• STAND-BY
• Automatic stand-by: When the system detects low temperature in the water inlet, it stops the fans and makes the red LED decreasingly blink.
When it redetects hot water, it automatically goes into AUTO mode.
• Stand-by manual: The user turns off the system. The red LED remains fixed. Until you reactivate the system, the system will not go into any
mode.
*NOTE: If you have turned on the boiler or the thermic group and its Varese HE emitter does not start automatically without being on stand-by
manual mode, check that the holder or the thermostat tap installed is not closed completely.

ERROR MESSAGES

The HE system is ready to auto-detect malfunctions. To do so, the icons blink to report each error, as follows:
• AUTO mode blinking: error in the water detection sensor.
• STAND-BYr apid blinking: error in the ambient sensor.
• AUTO mode and Stand By blinking: error in both sensors.
If any of these errors occur, contact the Ferroli Technical Service.
40
Operation
Fig. 43