Preliminary Operations - Clatronic BQS 2794 Instrucciones De Servicio

5....-05-BQS 2794
Overview of the Components
1 Heating element
2 Temperature regulator
with control lamp
3 Fixing screw
4 Leg
5 Grill tray
6 Grill grid
a Wing nut
b Screw
You can assemble the grill with the legs as a stand-alone device or without the legs
as a table grill. Please assemble all the parts as shown in the diagram.
Grill tray:
• Release the fixing screw (3).
• Remove any packaging material that may be present.
• Clean the gridiron (6) and the reflective metal sheet (10) with a damp cloth.
• Fix the heating element (1) back into place with the screw (3).
• Hook the feet (11) into the brackets on the bottom of the grill trough.
• Fill in 1.5 m of cold water up to the "MAX" mark in the trough.
Stand-alone grill (see illustration 1):
• Insert the assembly trestle (c) as far as the drill hole in the middle of the leg (d).
• Hook the journal of the assembly trestle (c) into the holes of the free surface
(12).
• Fix the components using the screw (b) and the wing nut (a).
• When all the legs have been assembled, attach the feet of the grill trough on to
the top ends of the legs.
• Please check whether all the legs are correctly positioned in the feet.
Before using for the first time, fill the grill tray with water and use it for 15 minutes to
remove the protective film from the heating coil. Select the MAX thermostat positi-
on. The presence of smoke is normal. Make sure that a sufficient level of ventilation
is available.
Preheat the device before use for approximately 5 minutes.
• Insert the plug in a duly installed 230V/50Hz protective contact socket.
• Set the thermostat for the desired use: a low or medium temperature for war-
ming or cooking, MAX. for rapid cooking and grilling. The LED shuts off when
the desired temperature is reached.
11.03.2003 14:05 Uhr

Preliminary Operations

7
8
9
10 Reflective metal sheet
11 Stand
12 Grill shelf
c
d
Usage
Seite 29
Handle
Wind protection
Heating grill
Assembling trestle
Standing leg
GB
29