Peavey CS 800S Guía De Operación página 7

Ocultar thumbs Ver también para CS 800S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

THE Sl OUTPUT
MODULE REAR VIEW
LOW CURRENT
STEREO MODE (18)
(Option 1)
This Sl module is shipped
wired as follows: lt as the
channel signal output and 1
as the channel chassis
ground. This is really the
defacto standard for most
low-to-medium power
loudspeaker systems. This
wiring allows one enclosure
to be connected to channel
A, and one enclosure to be
connected to channel B. The
2 t and 2 - connections are
simply not used in this
application! In this case the
2 t and the 2 - spades are
used to "store" the jumper
cables for later usage.
THE Sl OUTPUT
MODULE REAR,VIEW
HIGH CURRENT
STEREO MODE (19)
(Option 2)
Many larger loudspeaker
systems use the full
capability of the SPEAKON
connector by paralleling 1 t
and 2t, and paralleling 1 -
and 2 -. This wiring improves
the current handling
capability of the system and
reduces losses. Most "subs"
with SPEAKONs are wired
this way. This module can be
easily re-wired to this
configuration using the
supplied jumpers on the rear
of the module. Normally four
jumpers are plugged in a no-
connect configuration for
"storing". In this case, one
jumper is connected
between 1 t and 2t and
another jumper is connected
between 1 - and 2 - for each
channel. This is a total of
four jumpers. The diagram (19) shows the wiring of the jumpers.
THE Sl OUTPUT MODULE REAR VIEW - BRIDGE MODE (20) (Option 3)
This module can be re-wired to allow the SPEAKONs to be the bridge outputs with both in parallel. This arrangement would allow for
example, two 8 ohm enclosures to be connected in parallel to the CS 800s in bridge mode. In this case the wiring is as follows:lt on
both connectors wired to channel A signal output; 1 - on both connectors wired to channel B signal output; 2t and 2 - on both

Publicidad

Tabla de contenido
loading

Tabla de contenido