Wheel Locks - Ki Mobility Ethos Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
I. Wheel Locks
1. Adjusting Wheel Locks
a. Use a 6mm Allen wrench to loosen the clamp bolt (Fig. 8:A).
b. Slide the wheel lock assembly forward or backward along the lock mount tube.
c. Retighten clamp bolt when in correct position using a 6mm Allen wrench.
d. Always test new wheel lock positioning before use. Wheel lock should embed approximately
1/8" into tire when engaged or in lock position. See Fig. 9.
NOTE: The wheel lock arm can be moved along the different sets of holes on the wheel lock bar.
Use a 4mm Allen wrench to remove the two bolts, move to new position and reinstall bolts. See
Fig. 10.
Fig. 10
Fig. 8
A
Wheel lock
should embed at
least 1/8" into
tire when locked.
Fig. 9
Set of holes are
shown as dotted
lines because their
view is obstructed
by the clamp.
18