Skil 1840 Instrucciones De Funcionamiento página 7

Brought to You by www.snapwhole.com
SM 2610995799 3/03 3/3/03
SELECTING BITS
A wide assortment of router bits with different
profiles are available as accessories.
To prevent personal injury.
WARNING
!
Always remove the plug
from power source before removing or instal-
ling bits or accessories.
INSTALLING AND REMOVING BITS
(Standard models only)
1. Place router upside down as shown in (Fig.
3), or lay router on its side with the flat side of
base resting on the bench.
2. Press collet lock to stop rotation of collet
INSTALLING AND REMOVING BITS
(Wrenchless models only)
1. Place router upside
down on bench.
2. Pull chuck sleeve up
(away from tool) firmly to
release collet, and insert
a bit as far as it will go.
If cutting edges touch
the collet, retract the bit
until the cutters are
about 1/16" from the
face of the collet.
3. Push the collet sleeve
down firmly (towards the
tool) to fasten bit in
place.
COLLET LOCK
(Standard models only)
FIG. 3
3:55 PM Page 7
Assembly
nut. NOTE: it may be necessary to rotate
collet nut to engage collet lock.
3. With the wrench provided, turn collet nut
counterclockwise to loosen.
4. Insert bit three fourths into the collet, and
securely tighten collet nut clockwise with the
wrench provided.
CAUTION
!
without a bit.
Repeat steps 1, 2 and 3 of above and remove
bit.
To remove bit, place the router upside down
on the bench, pull up on the collet sleeve to
release the bit, and carefully remove it.
ATTENTION: Be sure that the diameter of the
bit shank is the same size as the inside
diameter of the collet — your router is
equipped with a 1/4" collet.
CHIP DEFLECTOR
The chip deflector helps keep dust and chips
out of your face. To remove, press inward on
center of deflector until it releases from tab in
base and lift out. To attach, place deflector
into position as shown in (Fig. 1). Then flex
sides of deflector while pushing down until
tab on base snaps into slot on deflector.
WARNING
!
BIT
SHANK
COLLET NUT
BIT
COLLET
BASE
-7-
To prevent damage to tool,
do not tighten collet nut
REMOVING BITS
REMOVING BITS
Safety glasses must always
be worn.
COLLET NUT
WRENCH
(Standard models only)