Publicidad
Idiomas disponibles
Idiomas disponibles
3. Connect one end of the long dupont cable to the inputs marked as V + GND M1 M2 and
the other end pass through the oval hole on the edge (to connect it to the sensor board
later).
4. Place the sensor card face down as shown in the image. Insert the thin screw from the
bottom up and secure with a nut.
NOTE:For better line reading, make sure that the
card has a distance of
approximately 5 mm from the
ground.
5. Connect the end of the long dupont cable
long that was loose in V + M2
bo tt om p art assembl y
R5
V+ GND M1 M2
R10
R8
R11
R9
R5
V+ BND M1 M2
V+
M2
R4
R4
R3
R2
R1
7
Publicidad
