Dichiarazione Di Conformità; Electrical Safety; Safety Instructions - KINZO 25C125 Manual De Instrucciones

DICHIARAZIONE DI CONFORMITÀ
Kinzo B.V. dichiara che le macchine:
Tassellatore 25C19
sono state concepite in conformità con i
seguenti standard:
EN 55014-1, EN 55014-2, EN 50144-1,
EN 50144-2-6, NEN 11000-3-2, EN 61000-3-3
con le seguenti direttive:
73/23/CEE, 89/336/CEE, 93/68/CEE,
98/37/EC
Ede, Paesi Bassi, Maggio 2004
Kinzo B.V., Postbus 735, 6710 BS Ede, Paesi Bassi
HAMMER DRILL
25C19
WARNING
Read this manual carefully before using the
machine, for your own safety.

SAFETY INSTRUCTIONS

When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
The following symbols are used throughout
this manual:
Denotes risk of personal injury
or damage to the tool.
22
e
M. Kinsbergen,
Direttore

ELECTRICAL SAFETY

Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION (fig. A)
Your hammer drill has been designed for
drilling in concrete, stone, wood and steel
and for light chipping and chiseling
applications.
1 On/off switch
2 Switch hammer function
3 Switch chisel function
4 Chuck
5 Collar
6 Depth stop
7 Side handle
8 Cover lubrication point
9 Carbon brush holder
Mounting and removing a bit or chisel (fig. A)
This tool uses drill bits and chisels with a
special tool holder system for quick and
easy mounting.
Apply a small amount of grease on the bit
I
or chisel shaft.
Pull the collar (5) backward and insert the
I
shaft of the bit or chisel into the drill
chuck (4). Turn the bit or chisel until the
shaft is locked in the drill chuck.
Release the collar (5).
I
In order to remove the bit or chisel,
I
pull the collar (5) backward and remove
the bit or chisel from the drill chuck.
Before mounting or removing a
bit or chisel, first remove the
mains plug from the socket.
Using the separate chuck (fig. C)
With the separate chuck your machine is
suitable for standard drill bits.
Select the drilling without hammering function.
I
Insert the adaptor (11) in the drill chuck (4).
I
25C19