Cleaning And Maintenance - KINZO 25C125 Manual De Instrucciones

To switch off the machine, release the
I
on/off switch.
Checking and replacing the carbon brushes
(fig. A)
The carbon brushes must be checked on a
regular basis.
Remove the carbon brush holders (9) and
I
clean the carbon brushes.
In case of wear, replace both carbon
I
brushes at the same time.
Mount the carbon brush holders.
I
After mounting new carbon brushes,
I
let the machine run at no load for
15 minutes.
Use only the correct type of
carbon brushes.
Lubrication (fig. A)
After approximately 50 hours the machine
must be lubricated.
Open the cover of the lubrication point (8)
I
using the supplied key.
Apply an appropriate amount of grease to
I
the mechanism.
Close the cover.
I

CLEANING AND MAINTENANCE

The machine does not require any special
maintenance.
Regularly clean the ventilation slots.
I
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
Speed (under load)
No. of strokes, under load
Drilling capacity in
steel
wood
stone
24
25C19
V 230
Hz 50
W 700
-1
min 850
min -1 3,150
mm 13
mm 40
mm 26
Chuck
on machine
separate
Weight
Level of sound pressure measured
according to EN 50144:
L (sound pressure)
pA
L (acoustic power)
WA
Take appropriate measures for
the protection of hearing.
Weighted root mean square acceleration
value according to EN 50144:
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
DECLARATION OF CONFORMITY
Kinzo B.V. declares that the machines:
Hammer drill 25C19
have been designed in compliance with the
following standards:
EN 55014-1, EN 55014-2, EN 50144-1,
EN 50144-2-6, NEN 11000-3-2, EN 61000-3-3
and
in accordance with the following directives:
73/23/EEC, 89/336/EEC, 93/68/EEC,
98/37/EC
special tool holder
13 mm
kg 4.5
25C19
dB(A) 94.5
dB(A) 107.5
25C19
6.75 m/s 2
25C19