Mettler Toledo IND780 Guia De Instalacion página 91

4. Finally, the back panel of the enclosure is sealed. Install three sealing screws as shown in
5. With the screws installed, thread the sealing wire through each of them, then thread the free
64057253 | 14 | 08/2014
Figure 2-108: Unprotected Option Board Connection
Figure 2-110 – two secure the panel in place on its stand-offs and one secures one end of the
upper card guide.
Figure 2-110: Panel Enclosure Rear Cover with Sealing Screws Installed
end through the hole in the plastic seal.
Wire retaining screws
Figure 2-109: Security Seal Installed
METTLER TOLEDO IND780 Installation Guide
2-67