GE Profile PV977 Manual Del Propietario E Instrucciones De Instalación página 18

INSTALLATION—VENTED TO THE OUTSIDE
STEP 6 CUT DUCT TO LENGTH
FOR VENTED INSTALLATION
• Measure from the hood exhaust opening to
the top of the supports as shown in the figure.
• Subtract any length of duct that is protruding
through the ceiling.
• Cut the 8" duct to the appropriate length. Attach
to ceiling duct using aluminized tape and screws.
Installation Instructions
Length of duct
needed minus the
length protruding
through the ceiling.
18
STEP 7 INSTALL HOOD ASSEMBLY
TO CEILING SUPPORT
WARNING:
to lift and position the hood onto the support.
• Lift the hood assembly up to the ceiling support.
Carefully fit the newly assembled duct over
exhaust opening on the hood assembly. The clips
on the ceiling support will snap into the large
openings on the upper vertical supports.
• Using the screws provided, attach the upper
vertical supports to the ceiling support, 4 screws
per side, for a total of 16 screws.
• Seal duct with aluminized duct tape.
Clips
Two people are required
Ceiling
support
Seal with
aluminized
duct tape