Guided Tour - Ur1 Receiver Rear Panel And Frequency Conversion Chart - Samson UHF Serie Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Guided Tour - UR1 Rear Panel
1
DC INPUT
+
CAUTION:
USE SAMSON
AC ADAPTOR
ONLY
CABLE LOCK: LOOP THRU AND TIE
1: DC input - Connect the supplied 12 volt 160 mA power adapter here, using the strain
relief as shown in the illustration below. WARNING: Do not substitute any other kind of
power adapter; doing so can cause severe damage to the UR1 and will void your warranty.
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
2: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the UR1 to consumer (-10) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced
output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up
and Using the Series One System" section on page 8 in this manual for more information.
4: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR
jack when connecting the UR1 to professional (+4) audio equipment. Pin wiring is as
follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
* If required, both the unbalanced and balanced outputs can be used simultaneously.
UHF Series One Frequency Conversion Chart
2
UNBALANCED
OUTPUT
-
-10dB 5KΩ
Channel
U1
801.375 MHz
U2
801.875 MHz
U3
803.125 MHz
U4
803.750 MHz
U5
804.500 MHz
U6
804.750 MHz
3
BALANCED SWITCH
LINE:
-20dBm600Ω
MIC:
-40dBm600Ω
MIC
LINE
POWER RATING
DC 12V, 1.9W(160mA)
-
Frequency
6
4
BALANCED OUTPUT
XLR:
1 GND
2 HOT
3 COLD

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

OneUr1Ut1lUt1gUh1

Tabla de contenido