Publicidad
Idiomas disponibles
Idiomas disponibles
When clamping drill bits, insert to
minimise projecting length.
Long shafts bend easily and degrade
true run.
We recommend PROXXON collet
chucks for optimal true running.
Using the machine
Important!
Always wear protective goggles
when using the machine.
Never use damaged grinding wheels
or bent shafts.
1. Switch on machine at switch 4
(Fig. 1) and set the appropriate
operating speed at button 1
(Fig. 1).
Note:
Optimum grinding results are
achieved through uniform speed and
not by applying excessive pressure.
Small cutters/bits = high speed,
Large cutters/bits = low speed.
2. When cutting or engraving, hold the
machine as if it were a pen (Fig. 3),
being careful not to occlude the
vent slits.
3. For roughing down, grip the machi-
ne as if it were a hammer (Fig. 4).
Care and maintenance
When finished using the machine,
unplug it and remove any dust cling-
ing to vent slits.
Disposal:
Please do not dispose of the device in
domestic waste! The device contains
valuable substances that can be recy-
cled. If you have any questions about
this, please contact your local waste
management enterprise or other cor-
responding municipal facilities.
EC-Declaration of conformity
We declare on our own responsibility
that this product conforms to the
following EC guidelines:
EC EMV Guideline 2004/108/EG
DIN EN 55014-1
DIN EN 55014-2
DIN EN 61000-3-2
DIN EN 61000-3-3
EC-Machine Guideline 2006/42/EG
DIN EN 60745-1
20.06.2008
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Härebierg 6-10
L-6868 Wecker
Equipment Safety Division
06.2007
08.2002
10.2006
06.2006
06.2007
- 7 -
Publicidad
