Troy-Bilt 020210 Manual Del Operador página 9

Section 3: Assembly
2.
Similarly. attach other end of high pressure hose to
high pressure oudet on pump (Figure 5). PuHH down on
coHHar o f quick connect, sHideonto pump and Hetgo of
coHhr. PuHH on hose to be sure of tight connection.
pressure hose here
3.
Before connecting garden hose to water inHeLinspect
inHetscreen (Figure 6).
CHeanscreen if it contains debris, repHace if damaged.
DO NOT RUN PP, ESSUF{EWASHERIF SCP, E EN IS
DAHAGED.
K Z_._/<_/__ NOT use if
'-_ _amaged, dean if
dirty.
4. Run water through garden hose for 30 seconds to
dean out any debris.Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water suppHy.Use ONLY coHd water (Hessthan H OO°F).
5. Connect garden hose (not to exceed 50 feet in Hength)
to water inHet.Tighten by hand (Figure 6).
Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
WANNING
AJw_ys wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggJes.
CbecMist Before Startin ine
Review the unit's assembHy to confirm you have performed
aHH of the following:
H. Hake sure handHe is in pHace and secure.
2. Check that oiH has been added to proper HeveH in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for property attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water suppHy (not to exceed HOO°F)
at an adequate flow.
7, Be sure to read "Safety 9,uHes"and "HowTo Use
Pressure VVasher" before using pressure washer,
0