Remote Control - Heatsail DOME Manual Del Usuario

Please exercise caution
in strong winds
Fix your DOME® in place or order
extra weights!
Secure the tube with the 2 screws
supplied, ensuring it can't revolve.

Remote control

LIGHT ON
KEEP THE BUTTON PRESSED DOWN TO DIM
PRESS IT AGAIN FOR THE ORIGINAL SETTING
LIGHT OFF
Heatsail lighting programming
Switch on the mains
power
(1) Switch on the mains
power
(2) Beware of any
exposed wiring
(3) The LED indicator
on the receiver will be
permanently lit when
there is power
12
Register transmitters with the recipient
(1) Press on the connect button for 1 second. The search mode will be active for 15
seconds and the LED indicator on the receiver will flash slowly.
(2) Send an on-signal with a transmitter whilst the search mode is active in order
to store the applicable transmission code in the receiver's memory. This will nor-
mally be the button at the top left. You can also choose a different button.
(3) The connected lights will switch on/off 2x to confirm the code has been stored.
Repeat this procedure to register several transmission codes, if so required. The
receiver can store 6 different transmission codes in its memory. The memory will
be retained if you install the receiver somewhere else or if the power goes off.
Heatsail DOME®