•
Fill the tank with fresh, still water (Fig. 4).
•
Switch on the appliance by pressing the power on/off switch (Fig. 14).
•
Buttons A-B-C will blink simultaneously to indicate that the machine is warming up. When
the buttons remain steadily lit, the appliance is ready for use.
DESCALING SIGNAL:
•
When warning light D blinks YELLOW, a descaling cycle should be carried out (see ch.
Descaling).
HEATING UP:
•
Buttons A-B-C blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
•
The water tank is empty when indicator light D blinks RED and the appliance emits 3
beeps followed by a single intermittent beep.
•
Fill the water tank with fresh, still water (Fig. 4).
•
Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling
cycle.
•
When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
IF THE LEVER IS RAISED WHILE DISPENSING:
•
Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
•
Warning light D blinks RED and the machine emits a single intermittent beep. The
appliance will immediately stop dispensing.
•
Close the lever (Fig. 3).
•
Press one of the buttons A-B-C to reset the alarm.
•
The appliance is ready for use again.
Adjusting the cup/espresso cup height
•
The machine can be adjusted for the use of large cups or espresso cups.
•
The machine is initially set for the use of large cups (Fig. 7).
•
To achieve the best results when using espresso cups, you must lift and turn the grid on
top of the drip tray (Fig. 10).
•
At this point you may place an espresso cup under the coffee dispensing spout (Fig. 8).
•
If using tall glasses, you will need to remove the drip tray (Fig. 15).
•
At this point you may place a tall glass under the coffee dispensing spout (Fig. 16).
English
Turning on the appliance
General operating indications
19