•
Fill the tank with fresh, still water (Fig. 4).
•
Turn the appliance on by pressing the On/Off switch I.
•
Buttons A-B-C will blink simultaneously; the machine is warming up. When the buttons light up
steady, the appliance is ready to dispense coffee.
•
Fill the jug with the desired amount of milk.
•
Position the milk jug lid.
•
Make sure the milk jug knob is in the dispensing position (Fig. 10).
•
Fit the milk dispenser fi rst and then the jug in its special place (Fig. 5). Buttons D-E-F blink.
•
When buttons D-E-F light up steady, the machine is ready to dispense milk.
DESCALING SIGNAL:
•
When the indicator light H blinks YELLOW, it is advisable to do the descaling cycle (see the
section Descaling).
COFFEE CIRCUIT HEATING:
•
Buttons A-B-C blink simultaneously.
MILK CIRCUIT HEATING:
•
Buttons D-E-F blink simultaneously.
WHEN THE WATER FINISHES DURING OPERATION:
•
When the indicator light G blinks RED and the machine beeps intermittently, the water tank is
empty.
•
Fill the water tank with fresh, still water (Fig. 4).
•
Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling cycle.
•
When buttons A-B-C light up steady, the appliance is ready to use.
IF THE LEVER IS RAISED DURING DISPENSING:
•
Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water. Danger
of scalding!
•
Indicator light G blinks RED and the machine beeps intermittently. Dispensing stops
immediately.
•
Close the lever (Fig. 3).
•
Press one of the buttons A-B-C to reset the alarm.
•
The appliance is ready to use again.
Adjusting the cup / espresso cup height.
•
The machine can be adjusted for the correct use of large cups or espresso cups.
•
Initially, the machine is arranged for large cups, to be placed on the drip-tray grille (Fig. 8).
•
For better results when using espresso cups, lower the top grille for cups (Fig. 7).
•
An espresso cup can now be placed under the coffee dispenser (Fig. 9).
English
Turning on the appliance
General operating indications
21