Troubleshooting; Technical Data - Caffitaly System S22 Manual De Instrucciones

Ocultar thumbs Ver también para S22:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 48
PROBLEM
No coffee comes out. The
indicator light G blinks
RED.
The coffee is not hot
enough.
The lever cannot be
lowered.
Indicator light G is on
steady and RED.
When a button is pressed
to dispense coffee, the
machine seems to start
but then stops without
dispensing coffee, or only
dispenses a small amount.
Coffee is dispensed very
slowly, and is of poor
quality.
The milk jug will not fi t.
Approx. 6 kg
1.3 litres
ambient temperature:
10°C ÷ 40°C
375 mm
220 mm
26
English

Troubleshooting

POSSIBLE CAUSE
The water tank is empty.
- Cold cups / espresso cups.
- Scale build-up in machine.
- The used capsule drawer
is full.
- Capsule stuck inside the
machine.
Heating problems.
Incorrect programming of
amounts.
Button C was used with an
espresso capsule.
Wrong position of pin in jug lid. See Fig. 18 and the section "Daily

Technical data

See the data plate on the
bottom of the machine.
Max. 15 bar
< 70dB A
18 capsules
280 mm
Fill the tank with fresh water. Press
a button to refi ll the circuit. When the
buttons are lit up steady, the appliance
is ready to use.
- Preheat the cup.
- Descale.
- Empty the used capsule drawer.
- Remove the stuck capsule.
Turn the machine off, then on again. If
the problem persists, take the machine
to an Authorised Service Centre.
Reprogram the amount for the button.
See the section "Programming the
amount of coffee in a cup".
Use buttons A or B.
Cleaning".
360 mm
CURE
The materials and
objects that come into
in contact with food
products comply with
the requirements of
European Regulation
1935/2004.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido