Cleaning And Maintenance - Marta MT-1349 Manual De Instrucciones

 To prevent motor overheating cleaner do not use vacuum cleaner continuously for more than 30 minutes and always take a break for at least 15 minutes.
 After cleaning: switch off the appliance by pressing On / Off button on vacuum cleaner housing. Disconnect the mains plug. By clicking rewind button, wait until the cord is fully rewound onto the drum inside
the unit.
 In case of overheating unplug the appliance, wait for 30 minutes, remove all possible obstacles in ingoing airflow holes, then switch on again. The device is ready. If the problem persists, contact the service
center.

CLEANING AND MAINTENANCE

 Unplug the power and let it cool before cleaning,
 Wipe the outer surface with a soft cloth with detergent that does not contain abrasives.
CLEANING THE DUST BAG:
 To remove dust container and filter press lock button, pull the handle and remove it, then empty by clicking the button (picture 1).
 Open the lid of dust container and shake to remove all dust , pressing the button (picture 2).
 Turn the lid and remove the filter dust collector (picture 3)
 Wash the filter in warm water, dry it in the air, and then bring it back or replace it with a new one.
Picture 1
CLEANING THE FILTER:
 Cleaning the filter should be done as it is dirtying.
 Use the vacuum cleaner only with the filter fitted. Operation without filters may reduce the suction power and damage the motor.
 Always unplug the vacuum cleaner from the mains before cleaning filter.
 Don‟t clean filters in laundry washer.
 Don‟t use hair-drier to dry filters.
 Before removing the filter, make sure that the regulator on the container to collect dust in the open position (picture 4)
 Take the handle and turn it to the left to remove the filter from the dust collecting container (picture 5)
 After cleaning, replace the filter in the dust container, grasp the handle and turn it clockwise until it clicks (picture 6)
 Wash the filter in warm water, using a brush. (picture 7)
 Let the filter dry completely after cleaning, then reinstall it.
Picture 2 Picture 3
13
MT-1349/MT-1350