Temporary Installation Of The Back Wall - MAAX BOSCA 6030 Guia De Instalacion

4
Temporary installation of the back
STEP
wall
Pull back the protective film on the walls (14-15) at least
3" away from all edges. Keep the remaining protective
film on the walls and base.
Position and level the back wall (14) by sitting it on the
deck at the back of the bathtub.

Installing the walls temporarily will
Quick tip
ensure proper wall alignment before
permanent installation.
Make sure the wall is plumb and
centered on the bathtub.
With a 1/8" bit, drill holes in the back wall fastening
flange (14) at the top aligned with each stud. Only pre-
drill the flange not the studs. Then, secure the back
wall (14) with one #8 x 1¾" screw (not included) in one
of the pre-drilled holes.
IMPORTANT: HAND TIGHTEN ONLY. TEMPORARY
INSTALLATION.

Push the bottom of the back wall
Quick tip with your foot when fastening in
place.
Check me!
Check me!
Plumbing the back wall is
critical for alignment of the
side walls
Check me!
min.
3/16
max.
3/8
10
4.1
4.2
Back wall
Bathtub
deck
4.3
"
"
Stud X fastener
14