DESCRIPTION OF THE APPLIANCE
A - Filter holder
B - Drain pan
C - Perforated silicone disc (Thermocream ®)
D - 1 cup filter/pod
E - 2 cup filter
F - Power cord + Plug
G - Removable water tank
H - Maxi Cappuccino attachment and wand for water and steam supply
I - Removable cups grill
J - On/Off button
K - Drip basin
L - Coffee measure/presser
M - Steam dispensing knob
N - Boiler temperature light
O - Steam function switch
P - Boiler temperature thermometer (C° and F°)
Q - Coffee dispensing switch
R - On light
Identification data
In the label located under the support base of the machine there is the following identification data
of the machine:
• manufacturer and CE marking • electrical supply voltage (V) and frequency (Hz)
• model (Model.)
• serial number (SN)
When ordering at Authorized Service Centers, indicate the model and serial number.
PRELIMINARY PHASES FOR USE
Starting the appliance
Check that the domestic mains voltage is the same as the voltage indicated on the label of the
device. Then place the machine on a flat surface. Wash the tank when used for the first time and
fill it with cool tap water (MAX 1 litre), and then carefully push it into its seat (Fig. 3). The suction
tube must be inside the tank.
First start-up
After filling the tank with cool tap water, plug it into the electrical outlet, which must be equipped
with grounding unit. Switch on the machine by pressing the button (J) Fig. 1. The light (R) will turn
on to indicate that the machine is on.
If you are starting the machine for the first time or after a period of time during which it has
not been used, it is recommended that at least one cup of water be allowed to pass through
the boiler's hydraulic circuit.
Place a container with a capacity of at least half a litre under the coffee spout and Maxi Cappuc-
cino device (Fig. 5). Put switch (Q) on the coffee position (
• electrical power consumption (W)
• assistance toll-free phone number
). Wait that water comes out from the
17