Narrow suction nozzle with brush (P)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly
to the handle (H).
VACUMM CLEANER ASSEMBLY
IMPORTANT: Before fitting or removing attachments, always make sure that the vacuum cleaner has
been unplugged from the power mains.
- Mount the handle (H) onto the suction device (M) by slightly pressing it until the handle notch
perfectly fits inside the apposite slot on the suction device (Fig. 2). Slightly pull to make sure the
parts are properly assembled.
- Insert the suction device (M) into the air inlet opening (G) by slightly rotating it until it locks (Fig. 3).
- Insert the telescopic tube (O) into the handle (Fig. 4).
- Push the slider device (N) forwards and pull the bottom section of the tube out to the required
length (Fig. 5). To shorten the tube, push it back in the opposite direction.
- Fit the required attachment to the telescopic tube.
USING THE APPLIANCE
CAUTION: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord completely and plug the appliance
into the mains socket.
To switch on, press the foot switch (F) on the appliance. The cleaner is equipped with wheels to
move it easily during use.
IMPORTANT: The appliance might make a whistling sound that will stop after a few seconds.
WARNING: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube
become blocked. Remove the cause of the blockage before switching the vacuum cleaner on
again.
After using the cleaner
Switch off the appliance using the foot switch (F).
Then unplug the appliance from the mains power and hold down the foot pedal (C) on the appliance
until the power cord is fully rewound.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
Put away the appliance, placing the floor brush (L) on the special hook in the back (Fig. 6).
Carrying the vacuum cleaner
Only carry the appliance using the special handle on the top part (E).
- 9 -
EN