Technical Data - Brevi VIVALAPAPPA 352 Instrucciones De Uso

ISTR scaldabiberon W PAPPA 352-01:ISTRUZIONI scaldabiberon W PAPPA 352-01
GB
- Plug in the power cord: the green indicator light will light up – power on (fig.13)
- Set temperature by moving the knob to position "4" (fig.14)
- The red indicator light lights up indicating that the bottle warmer is being heated: when
the red light goes off (fig.15), wait about 30'' before removing the jar from the warmer by
holding the adapter containing the jar (fig.16)
For a greater safety, it is recommended to check temperature by putting a small amount
of food on the inside of your wrist (fig.17).
KEEPING WARM FOOD
If you want to keep the food warm for a certain period, leave the bottle and the jar in the
warmer when ON. In any case never leave them for more than one hour.
TABLE 1
TYPE
BOTTLE 125 ml
BOTTLE 250 ml
BOTTLE 330 ml
Baby food jar
IMPORTANT
1. Do not turn on the bottle warmer if there is no water inside the container.
2. Always check milk or food temperature before feeding your baby.
3. Always heat food in a water bath.
4. Do not heat food more than once.
5. Do not dip the bottle warmer into water; empty the container after use and
clean it with a damp cloth.
CONFORMS TO THE PROVISIONS STATED IN DIRECTIVE 2006/95/CE

TECHNICAL DATA

Model: code 352 Home Bottle Warmer Vivalapappa
Supply: 230V - 50 Hz
Power: 150W
Dimensions: 11,5x17,5x11,5 cm
Weight: 0,5 kg
14
30-04-2008
THERMOSTAT POSITION
between 2 - 3
3
between 3 - 4
4
WARNING:
HOT STEAM!
9:50 Pagina 14
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING REGARDING DISPOSAL OF THIS APPLIANCE IN COMPLIANCE
WITH THE PROVISIONS OF 2002/95CE – 2002/96CE – 2003/108CE EURO-
PEAN DIRECTIVES
The crossed-out wheeled bin symbol on this equipment means that this product
must be collected separately from normal wastes at the end of its useful life-
span.
At the end of the appliance useful lifespan, users must therefore take it to an
authorised disposal centre for the recycling of electronic and electro-technical
waste or they should take it back to the retailer upon purchase of a new, simi-
lar appliance, on a one-to-one basis.
An adequate separate waste collection system for later recycling, treatment and
environmentally-friendly disposal of the appliance avoids a negative impact on
the environment and health, as well as it facilitates the recycling of the pro-
duct's different components.
Users who dispose of products in an unauthorised manner shall be liable for admi-
nistrative penalties in compliance with Article 50 of the Legislative Decree No.
22/1997 and the following articles.
Brevi can make any change whatsoever to this instructions leaflet without any prior notice.
GB
15