Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
0NE-PIECEDOORS
Please read and comply with the warnings and reinforcement
instructions on the previous page. They apply to one-piece doors
also.
• Center the door bracket on the top of the door, in line with the
header bracket as shown. Mark either the left and right, or the
top and bottom holes.
• Metal Doors: Drill 3/16" pilot holes and fasten the bracket with
the 1/4"-14x5/8" self-threading screws provided.
• WoodDoors: Drill 5/16" holes and use 5/16"x2" carriage bolts,
lock washers and nuts (not provided) or 5/16"x1-1/2" lag
screws (not provided) depending on your installation needs.
NOTE: Thedoor bracket may be installed on the top edge of the
door if required for your installation. (Refer to the dotted line
optional placement drawing.)
HARDWARESHOWN
ACTUALSIZE
Self-Threading
Screw
1/4"-14x5/8"
Header Wall
Door
Bracket
2x4 Support
Optional
Placement
of Door
Bracket
Vertical
Centerline
of
Garage
--
Finished Ceiling --
HORIZONTAL
AND VERTICAL
REINFORCEMENT
IS NEEDED
FOR LIGHTWEIGHT
GARAGE
DOORS (FIBERGLASS,
ALUMINUM,
STEEL, DOORS
WITH GLASS
PANEL, ETC.).
NOT PROVIDED)
Door
Bracket
__
elf-Threading
Screw
;
1/4"- 14x5/8"
'
Top of Door
(Inside
Garage)
of Door
Placement
METAL DOOR
Nut
5/16"-18 _
Lock
Washer
,_
5/16"
Top of Door
(Inside
Garage)
Top Edge
of Door
Optional
Placement
For a door with no exposed framing,
or for the optional installation,
use
lag screws 5/16"x1-1/2"
(Not Provided)
to fasten door bracket.
'
Carriage
Bolt
_
_
5/16"x2"
(Not Provided)
WOOD DOOR
24
Publicidad
Capítulos
Tabla de contenido
