Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Lowering the vehicle
DANGER TO LIFE! Check that no person
or object is under the vehicle before you
lower it.
First raise the vehicle slightly (as described
earlier) in order to be able to remove the
axle stands.
Turn the release valve
the vehicle lowers, but do not turn it to the
extent that it detaches or hydraulic oil leaks
from the release valve
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
Pull the trolley jack out from under the vehicle
and fully lower the lifting arm
Close the release valve
clockwise.
Attaching the adapter
(optional)
From its original height (14.2 cm), bring the
vehicle jack to a height of 15.7 cm by mov-
ing the lifting handle
the section on „Using the jack").
Remove the hex bolt
with a socket wrench plus socket (19 mm)
and a ring spanner (19 mm) (see Fig. E).
Place the adapter
From above, guide the hex bolt
the adapter
and load plate
9
Fig. F).
At the same time as you are doing this,
place the nut
11
with the help of a ring spanner (see Fig. F).
Fix the hex bolt
10
together with a socket wrench plus socket
(19 mm) and a ring spanner (19 mm) (see
Fig. G).
Lower the vehicle jack back down to its orig-
inal height by turning the release valve
anticlockwise. Ensure that the release valve
does not become detached and allows the
22 GB/MT
anticlockwise until
5
.
5
.
2
by turning it
5
up and down (see
1
from the nut
10
11
on to the load plate
9
through
10
(see
3
under the load plate
3
and nut
in place
11
hydraulic oil to escape (see the section on
„Raising the vehicle").
If you no longer need to use the adapter
remove it by releasing the hex bolt
the nut
11
(19 mm) and a ring spanner (19 mm) (see
Fig. E).
Then fix the hex bolt
place together inside the load plate
safe keeping.
Cleaning and care
Never use harsh or corrosive cleaning agents.
Liberally grease all external moving parts.
Clean the hydraulic trolley jack using a
slightly oily cloth.
Fully lower the lifting arm
handle sleeve
trolley jack in the smallest possible space.
Maintenance and service
Note: Refilling or topping up with hydraulic
oil may only be carried out by specialist
personnel! Always use hydraulic oil that fulfils
the specification for SAE 10. Please note
that filling with too much oil may adversely
affect the functioning of the vehicle jack. Fill
.
with a maximum of 95 ml oil when all the
3
oil has been used. Fill the hydraulic oil res-
ervoir up to the bottom edge of the filling
opening (see Fig. H).
Note: We recommend having the equip-
ment inspected by a professional every
three years.
Defective hydraulic vehicle jacks must be
repaired by a specialist workshop only.
Never attempt to repair the hydraulic vehicle
jack yourself.
Never take the hydraulic vehicle jack to
pieces. Taking the vehicle jack to pieces
5
yourself may result in it not working properly.
5
with a socket wrench plus socket
and the nut
10
and lifting
2
to be able to store the
6
,
9
from
10
in
11
for
3
Publicidad
Tabla de contenido
