Recovery Tank - Tornado 98262 Manual De Instrucciones

NOTE - FOR COLOR FASTNESS: Before using carpet cleaning chemicals, test on an inconspicuous part of
the carpet for color fastness. Place the solution on a small piece of clean white cloth or tissue. Rub the carpet
area vigorously with the cleaning chemical. Excessive amounts of dye showing on the material would indicate
that the colors are not colorfast, and should not be wet cleaned.
VACUUM
SWITCH
RECOVERY
TANK
DUMP
VALVE
Fig. 2
1) Plug the power cord into an outlet. WARNING: This machine must be properly grounded. See Grounding
Instructions on page 4 for additional information.
2)With the solution line attached to the wand and the machine, press the pump switch to the "ON" position.
See Fig.1 for a diagram on the operation switches. Squeeze the lever on the wand and spray until there is no air
coming out with the water. This takes approximately 2-3 minutes.
3)With the pump still on, press the vacuum switch "ON" position. See Fig.1 for a diagram on the operation
switches.
4)To clean the carpet, squeeze and hold the lever on the wand to apply the cleaning solution,
5)For optimum cleaning results it is suggested to use a V stroke pattern. Start with an area approximately 4' x
4'. On the back stroke pull the trigger on the wand for the solution to spray. Release the trigger about 4 inches
before the end of the stroke for maximum water recovery. Push the wand forward at a slight angle until next
stroke is slightly overlapping previous stroke. Go over area just cleaned with vacuum only stroke before mov-
ing to the next area. After a few passes, check the recovery tank to verify that no foam is present. Add extra
de-foamer if necessary.
6)Empty the recovery tank when it is approximately 3/4 full by pulling up on the handle on the dump valve.
7)When finished, turn all switches "OFF". Before disconnecting solution hose relieve the water pressure from
the wand by squeezing the lever on the wand. WARNING: Turn unit off immediately if foam or liquid comes
from machine exhaust. Empty & clean out recovery (dirty) tank and use de-foamer to correct the problem.
8) To further decrease the drying time, use a Windshear Storm, or any other Windshear Carpet Blower that is
appropriate to the size of the area cleaned.
PUMP
SWITCH
Fig. 1
VACUUM
SOLUTION
HOSE
TUB
SOLUTION
INLET HOSE
SOLUTION
DELIVERY
HOSE
1) Prepare room for cleaning, moving furniture as need
to provide a clear working area. Cover bottoms of
furniture legs where possible. (Aluminum foil or foam
blocks are ideal for this purpose.) Pin up curtains and
drapes.
2) Gather cleaning supplies: a clean, suitable sized
bucket, carpet cleaning solution, de-foamer solution,
and pre-treat solutions for heavily soiled traffic areas.
3) Measure carpet cleaning solution, per manufacturers
recommended ratio, into the bath tub (or bucket) and fill
with hot water up to ½ of standard bath tub.
WARNING: DO NOT exceed water temperature of
150º (65º C).
4) Place solution hose into tub making sure it is resting
on bottom of tub.
5) With switches turned off connect the solution hose
and the vacuum hose to the machine and to the wand.
WARNING: Do not attempt to connect solution hose to
machine with pump switch turned on.
7