Introduction; Explanation Of Symbols; Safety - Siemens Nixdorf MCM 1701 Instrucciones De Servicio

Introduction

This Operating Manual contains all the information you require to start up and run
your monitor.
Whom does this manual address
You don't need to be an "expert" to perform the operations described here. Do,
however, read the chapter with the important notes at the beginning of the
Operating Manual of your PC and the various notes in each chapter.
In case of difficulties please contact your local service point.
Where to find further information
For specialists such as service technicians and developers of hardware and
software, there is a Service Manual and a System Manual containing further
system information.

Explanation of symbols

The meanings of the symbols and fonts used in this manual are as follows:
Pay particular attention to texts marked with this symbol. They always
!
contain important information.
i
This symbol is followed by supplementary information, remarks and tips.
Texts which follow this symbol describe activities that must be performed in the
order shown.
"Quotation marks" indicate highlighted text and names of chapters.
A26361-K316-Z1-2-6419
17" color monitor

Safety

This device complies with the relevant safety regulations for data processing
equipment, including electronic office machines for use in an office environment. If
you have any questions, contact our customer service.
– Transport the device only in its original packaging or another corresponding
packaging (to protect it from knocks and jolts).
– If the device is brought into the installation site from a cold environment,
condensation can form. Since the device must be absolutely dry before it is
placed in operation, an acclimatization period of at least two hours is required.
– During installation and before operating the device, observe the instructions on
environmental conditions in the chapter entitled "System unit" and the
instructions on installing the monitor and setting up the device in the operating
manual of your PC.
– This device has a safety-tested power cable and may only be connected to a
properly grounded plug socket.
– The device must be installed in such a way that the user has good access to the
appliance socket (fully insulated socket) or the grounded-contact utility power
socket.
– Lay all cables so that nobody can stand on them or trip over them. When
attaching the device, observe the relevant notes in this chapter.
– No data transfer cable and no power cable should be connected or
disconnected during a thunderstorm.
– In emergencies (e.g. damaged casing, penetration of liquids or foreign matter),
switch off the unit, disconnect the power plug and contact the appropriate
customer service.
– Only qualified technicians may repair or open the monitor.
– Do not open the power supply (identified by a label). Only qualified personnel is
allowed to remove it.
– When cleaning the system unit, observe the relevant notes in chapter "Cleaning
the monitor".
– Keep the monitor away from strong magnetic fields.
English - 1 2 - English
A26361-K316-Z1-2-6419