Maintenance; Glass Information; Maintenance Of Motors; Battery Replacement - Muskoka MH35ABB Guía De Uso Y Cuidado

Maintenance

DANGER: Disconnect power before servicing.
WARNING: Any electrical re-wiring of this appliance must be done by a qualified electrician. This
wiring must be done in accordance with local codes and/or in Canada with the current CSA C22.1
Canadian Electrical Code, and for US installations, the National Electrical Code ANSI/NFPA NO 70.
WARNING: If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.

GLASS INFORMATION

1. Under no circumstances should this product be operated with a broken or chipped glass panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleansers to clean the glass. Make sure the glass is cool to the touch.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done
by qualified/authorized service personnel only.

MAINTENANCE OF MOTORS

1. Always disconnect the appliance from the main power supply and allow it to cool before any servicing
operation.
2. The motors used on the fan heater and flame blower are pre-lubricated for extended bearing life and
require no further lubrication. However, periodic cleaning/vacuuming of the appliance around the air
intake and exhaust, as well as the fan heater is reccomended. For heavy or continous use, periodic
cleaning must be done more frequently. If the heater blows alternating cold and warm air, check the fan
for free movement and for debris restricting air flow. If the fan does not move freely, the unit be turned off
and fan replaced immiediately in order to prevent further damage to the unit.

BATTERY REPLACEMENT

3 Volt lithium coin cell type 2032. Please dispose of the used battery per municipal or provincial/state law.
1.
THIS PRODUCT CONTAINS A BUTTON BATTERY. IF SWALLOWED, IT COULD CAUSE SEVERE INJURY
OR DEATH IN JUST 2 HOURS. SEEK MEDICAL ATTENTION IMMEDIATELY.

Care and Cleaning

1. Always turn the heater OFF and unplug the power cord from the outlet before cleaning.
2. Cleaning of the control panel is to be done only using a soft cloth, slightly dampened in water (if needed,
a small amount of dish soap can be added to the water) and dried using a clean, dry soft cloth. Cleaning
of the screen diffuser is to be done using only water and lint free cloth. DO NOT use any abrasive on the
controls or the diffusing screen.
12
2. 3. 4.