Publicidad
Idiomas disponibles
Idiomas disponibles
BELT-STRETCHER CONTROL ADJUSTMENT (Fig. 8)
halftravel. When lever is pulled to full extent (working position), the belt-stretcher load spring (2) should extend by 6 to 8 mm approx. For above
described conditions be reached, action is to be taken on nut (1) set close to the belt stretcher control assembly.
REGULATING THE HANDLEBAR
procedure to adjust the handlebar to the needs of the operator so that the machine can be easily manoeuvered at all times. The handlebar can be
side adjusted so that the operator can use the machine without treading in the soft ground or damaging the crop.
HANDLEBAR SIDE ADJUSTMENT (Fig. 2)
rear-mounted attachments such as a cultivator or with front-mounted attachments such as a mower. Follow these steps: Turn lever (8) anticlockwise
to disengage the clamp. Move the handlebar to the position you want it in. Clamp the handlebar again by turning lever (8) clockwise and check to be
sure that the teeth are perfectly meshed.
When turning the handlebar 180°, do so only clockwise so as not to damage the wires that run along the column. Furthermore, detach the gear
change rod (4) and reconnect it when the handlebar is in its new position.
When the handlebar is turned 180°, the position of the gears will be reversed - in other words, the reverse gear will become the forward gear and
vice-versa.
HANDLEBAR HEIGHT ADJUSTMENT (Fig. 2)
screws (3).
CUTTING BAR HEIGHT ADJUSTEMENT (Fig. 9)
of terrain being cut. Follow these steps: a) Slacken off nut (1) - b) Move the shoes (2) to the required position - c) Retighten the nuts (1). Repeat on
the other shoe.
REGULATING THE KNIFE (Fig. 10)
means of screws (1) and their locknut. To check the results after each regulation, first remove the cowling and then turn pulley (2) slowly by hand and
check to make sure that the knife is moving easily.
DEPTH ADJUSTMENT (Fig. 11)
setting device (1) that regulates spade working depth. When the depth control lever (2) is pulled back and moved up or down, spade penetration into
the soil is regulated. The cultivator is correctly regulated when the machine moves forward smoothly without lifting out of or digging into the soil. In the
first case (lifting out), move the lever to position "B" and in the latter case (digging in) move the lever to position "A". CULTIVATING HARD GROUND:
move the depth lever to position "B". This position corresponds to a small soil penetration depth. CULTIVATING SOFT GROUND: move the depth to
position "A". This position corresponds to a deep soil penetration depth.
Turn the engine on with the depth lever in position "B" as this enables the spades to break up the top surface.
Warning - Tyres should start rotating only when control lever is beyond
The handlebar can be height or side adjusted. Before beginning any work, it is good standard operating
There are three positions for the handlebar side adjustment and these can be used either with
1) Slacken off screws (3), adjust the handlebar to the required height 2) re-tighten the
Adjust cut height with the adjusting shoes as needed but bearing in mind the type
After changing knife or after a certain number of work hours, the knife guide should be regulated by
To ensure good soil cultivation and smooth machine movement, the attachment/ cultivator has a depth
11
Publicidad
