Squeegee Cleaning; Squeegee Blade Check And Replacement - Clarke Vantage 17 Battery Libro De Instrucciones

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and the blades must be
in good condition in order for the floor to dry properly.
CAUTION!
It is advisable to use protective gloves when
cleaning the squeegee because there may be
cutting debris.
1. Make sure that the switches (A and B, Fig. 24) are in the "0"
position.
2. Lower the squeegee (D, Fig. 24) by means of the lever (C).
3. Disconnect the vacuum hose (E, Fig. 24) from the
squeegee.
4. Loosen the squeegee knobs (F, Fig. 24) and remove the
squeegee (D).
5. Wash and clean the squeegee assembly to remove dirt and
debris.
6. Check the front blade (C, Fig. 25) and the rear blade (D)
for wear, cuts and tears; if required, replace them according
to the procedure in the "Squeegee Blade Check and
Replacement" section below.
7. Reassemble in the reverse order of disassembly.
SQUEEGEE BLADE
REPLACEMENT
1. Clean the squeegee according to the procedure shown in
the previous paragraph.
2. Check that the edge (E, Fig. 25) of the front blade and the
edge (F) of the rear blade lay down on the same level, along
their length; otherwise adjust their height according to the
following procedure:
• Remove the fixing springs (G, Fig. 25) and adjust the
front blade (C) and the rear blade (D).
• Reinstall the fixing springs on the properly adjusted front
and rear blades.
3. Check the front blade (C, Fig. 25) and rear blade (D) for
wear, cuts and tears. If necessary, replace them according
to the following procedure:
• Remove the spring clamp (G, Fig. 25) and replace the
blade.
NOTE
When replacing the blades, make sure that the ribs of
the front blade face the front and the ribs of the rear
blade face the rear.
• Reinstall the spring clamps (G, Fig. 25).
4. Reinstall the squeegee (D, Fig. 24) and screw down the
squeegee knobs (F).
5. Connect the vacuum hose (E, Fig. 24) to the squeegee (D).
Operator's Manual - Vantage 17 Battery
CHECK AND
ENGLISH
Figure 24
Figure 25
19