Installation Dimensions - FAAC 412 Manual De Instrucciones

ENGLISH
These instructions apply to the following models:
Operators 412 and 412-24V
The FAAC 412 AUTOMATION SYSTEM for swing gates comprises
two electromechanical operators which drive the gate leaves
by means of a worm screw.
The system locks mechanically; therefore no electric lock is
required.
Ü Ü Ü Ü Ü To obtain anti-crushing protection, you have to use elec-
tronic control units with a torque control electronic device.
The 412 automation was designed and manufactured to con-
trol access of vehicles.
Avoid any other use whatever.
1. DESCRIPTION AND TECHNICAL SPECIFICATIONS
Table 1: 412 operator technical specifications
Power supply
Absorbed power (W)
Current drawn (A)
Electric motor
Motor winding thermal cutout
Capacitor
Max. thrust/traction force (daN)
Rod stroke (mm)
Rod speed (cm/s)
Temperature range (°C)
Operator weight (Kg)
Housing protection
Duty cycle (cycles/hour )
Maximum leaf length (m)
412 AUTOMATION SYSTEM
Motor Unit
Power cable
Worm screw
Front bracket
Rear bracket
Cable cover
Cover
Fig. 1
412 412-24V
230 V~ 50 Hz 24Vdc
280 70
1,5 3
1400 rpm
140 °C /
8 µF/400V /
350 250
290
1,6
-20 Ö +55 °C
6,5
IP 44
18 50
1,80
Drawing A

INSTALLATION DIMENSIONS

Table A: Recommended dimensions
Opening a
angle "α α α α α "
(mm)
90° 145
110° 125
(*) working excursion of piston rod (**)maximum dimensions
CALCULATING
GENERAL RULES
If modifications to the dimensions specified in Table A
are necessary, proceed as follows:
- For 90° leaf opening: a + b = c
- For leaf opening over 90°: a + b < c
- The lower the dimensions of a and b the higher the gate
speed. Always respect current standards.
- Limit the difference between a and b to within 4 cm: larger
differences alter speed considerably during opening and
closing.
- For reasons of operator clearance, the minimum value for
Z is 45 mm (fig. A)
If the dimensions of the gate post or position of the hinge do
not allow for the specified distance of "a", make a recess
in the gate post as shown in fig. B.
6
ENGLISH
b c (*) d (**)
(mm) (mm) (mm)
145 290
125 290
INSTALLATION DIMENSIONS:
Fig. A
100
80
Fig. B