Instructions For Connection To Power Supply & Elect. Ground, 230V - American Sanders Clarke Sander 1600 Libro De Instrucciones

Pin Earthing Contact
European Plug
Side Earthing Contact
Figure 9
Clavija de puesta a tierra
Enchufe europeo
Muescas laterales para puesta a tierra
Figure 9a
Broche de mise à la terre
Fiche européenne
Encoches latérales pour mise à la terre
Figure 9b
-20 - FORM NO. 70309B
INSTRUCTIONS FOR CONNECTION
CAUTION:
quency and electrical voltage shown on the nameplate.
Make sure you have the correct frequency and voltage
before connecting the power cord to an outlet.
This product must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance
for electric current to reduce the risk of electric shock. This
product is equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug must be
inserted into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
WARNING:
grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or service
person if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug provided
with the product - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
This product is for use on a nominal 230 volt circuit and has
a grounding attachment plug that looks like the plug
illustrated in Fig. 9. Make sure that the product is connected
to an outlet having the same configuration as the plug. No
adaptor should be used with this product.
WARNING:
mercially available floor cleaners and waxes intended
for machine application.
This machine is intended for commercial use.
This machine must be connected to the electrical ground to
protect the operator from electrical shock. The machine has a
power cord with two main conductors and one earthing con-
ductor. Connect the plug to the receptacle. The green and
yellow conductor in the cord is the ground wire. Never connect
this wire to any terminal other than the ground terminal.
WARNING:
conductor electrical system connected to the electrical
ground. Replace any worn, cut or damaged cords. Re-
place any damaged plugs, receptacles, or connector
bodies. Do not move the machine over an electrical cord.
Always lift the cord over the machine.
Use only an approved extension cord with two main conduc-
tors and one earthing conductor. The machine has a power
cord with wire size 1.5mm
WARNING:
sion cord with minimum wire size 1.5mm
an extension cord longer then 15 meters. Do not join
two extension cords.
WARNING:
terminal. Do not try to fit a three-terminal plug into a
receptacle or connector body that does not fit the plug.
If the receptacle or connector body does not fit the plug,
see your authorized Clarke American Sanders dealer to
get an authorized person to make the connection.
®
Clarke American Sanders Operator's Manual - Sander 1600/1600DC - 230V
240 VOLT MACHINES
TO THE POWER SUPPLY
AND THE ELECTRICAL GROUND
This machine will operate only on AC fre-
Improper connection of the equipment-
To reduce the risk of fire, use only com-
Always use this machine with an AC three-
EXTENSION CORDS
2 .
If you use an extension cord, use an exten-
Do not cut, remove or break the ground
2 . Do not use