Publicidad
Idiomas disponibles
Idiomas disponibles
3. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 2. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach the Mantel/Top (G) using
Bolts (AA) and Washers (BB) through the pre-drilled
holes in the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA
Bolt
BB
Washer
CC
Wood Dowel
4. Insert Center Upper Back Panel (P) into the groove
in the top of the cabinet as diagram 1. Push Center
Upper Back Panel (P) to connect the magnets with
the metal slip as diagram 2.
Locate Side Back Panel (J) and Center Back Panel
(I), attach to the back of the completed assembly
from step 3. Use a Phillips Head screw driver,
tighten screws (EE) through the pre-drilled holes in
the Back Panels to the completed assembly.
Hardware Used
EE
Screw
5. Locate Right Front Door (M) and Left Front Door
(L). Slide door hinge keyhole into panel hinge
bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change keyhole
slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c).
Attach the Knob (FF) to the Left Front Door (L) and
Right Front Door (M), use the bolts attached
through the pre-drilled holes in the doors. Then use
a Phillips Head Screwdriver to tighten the bolts.
Carefully align the metal tracks on the left and
right sides of the box with the extended
glides. Make sure Drawer (K) are aligned and
centered in Cabinet, then gently push the Drawer
(K) into place.
CAUTION: Do not force the drawer into place, as
the cabinet might be damaged as a result.
Hardware Used
FF
Knob
Fig. 3
x 9
x 9
x 8
Fig. 4
x 42
EE
Fig. 5
L
x 6
5
G
BB
AA
P
J
I
M
K
CC
J
FF
Publicidad
