Dd Door Touch Clip; Pivot Hinge; Gg Magnetic Spring Catch - Twin Star Home 26MM9404 Manual De Instrucciones

5. Insert Left Top Panel (M) and Right Top Panel (N),
from the inside, attach the Top panel using Bolts
(AA) and Washers (BB) through the pre-drilled
holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
6. Attach Side Back Panels (O) to the back of the
completed assembly from step 5. Use a Phillips
Head Screw Driver, tighten Wood Screws (JJ)
through the pre-drilled holes in the Side Back Panels
(O).
Hardware Used
JJ
Screw
7. Attach the Magnetic Spring Catch (GG) on the
bottom of Top Panel, tighten screws (KK) through
holes to the block as shown in diagram.
Place the Door Touch Clip (DD) to the glass door.
Insert the Pivot Hinge (FF) into the plastic mat as
shown in diagram. Then push the Glass Doors (L)
snug to the Pivot Hinges (FF), use a Phillips Head
Screwdriver to tighten the pivot hinge against the
glass.
WARNING
Do not over tighten catch screws.
Damage to the Glass could occur!
Hardware Used
DD
Door Touch Clip
FF

Pivot Hinge

Magnetic Spring
GG
Catch
KK
screw
Fig. 5
N
x 8
CC
x 8
BB
x 8
AA
Fig. 6
x 32
Fig. 7
GG
x 2
x 4
x 2
x 8
6
JJ
O
KK
L
FF
M
DD
BB
AA
O
DD
L