Charging Your Iphone Or Ipod; Listening To The Fm Radio - Altec Lansing iMT620 Guia Del Usuario

Charging Your iPhone or iPod

Whenever your iPhone or iPod is docked and your Altec Lansing inMotion
Classic speaker system is plugged into an AC outlet, your iPhone or iPod is
charging (until fully charged) – even if the speaker system is switched off.

Listening to the FM Radio

1
extend the FM antenna fully for
best FM reception.
2
Select "FM" mode.
Press the "SOURCE" button on your
speaker system or full-featured remote
until "FM" appears on the LCD.
3
Tune to the station you want to
listen to.
Use the or buttons on your
speaker system or full-featured remote
to tune in the desired station. Press
and hold these same buttons to find the next clear FM station.
4
Adjust the volume.
Use the "+" and "–" buttons on the Altec Lansing speaker system or
full-featured remote to adjust the system volume.
14
How to Store Preset Stations
Your Altec Lansing speaker system's full-featured remote enables you to
program up to 4 FM station presets:
1
Tune to the station you wish to store.
While in "FM" mode, use the
system or full-featured remote to tune to the desired station.
2
Store the station.
Press and hold the P1, P2, P3 or P4 button on the full-featured
remote for a few seconds. You can store one FM station in each
preset.
3
To store other stations, repeat the above steps.
How to Recall Preset Stations
1
Make sure you are in "FM" mode.
If you're not in "FM" mode, press the "SOURCE" button on your
speaker system or full-featured remote until "FM" appears on the LCD.
2
Press a PReSeT button (P1, P2, P3 or P4) on the full-featured
remote.
The radio will tune to your preset station.
3
Adjust the volume.
Use the "+" and "–" buttons on the Altec Lansing speaker system or
full-featured remote to adjust the system volume.
and buttons on your speaker