System Configuration - Conceptronic CM3S Manual Del Usuario

ENGLISH
You can press the 'Setup' button on your remote control to open the Setup Menu of the unit.
Press the / / / buttons to move the selection in the Setup Menu, and press the
confirm the selection. When you are finished with configuring your unit, press the Setup button again to
close the Setup Menu, or select the option 'Exit Setup' in the Setup Menu.
The Setup Menu contains the following options:
•
General Setup
•
Slideshow Setup
•
Preferences
•
Firmware Version
•
Exit Setup
General setup
Orientation
Preview
TV Display
TV SYS
SPDIF Output
Screen Saver
Slideshow setup
Slideshow Mode
Interval time
Trans speed
Transition
Preferences
Video Output
OSD Lang
OSD Message
Default
Auto Start
File Sort
Firmware Version
When selecting 'Firmware Version', the firmware version of your CM3S is shown in the lower left corner of
the Setup Menu.

9. System Configuration

: Remember the Rotation settings for each photo.
: Turn on or off the file preview mode.
: Change the TV Display setting.
: Select a video system for your TV.
: Enable or disable the SPDIF Output of the unit.
: Enable or disable the Screen Saver.
: Configure the Slideshow mode.
: Select the interval time between two photos.
: Select the transition speed between 2 photos.
: Select the default transition used between 2 photos.
: Set the video output signal for the unit.
: Set the onscreen display language.
: Enable or disable OSD messages during playback.
: Reset the unit to the factory default settings.
: Automatically play all media files on the CM3S when the unit is turned on.
: Select how to sort the files on the CM3S.
27
/ ENTER button to