Mounting The Solar Cell; Connecting The Solar Cell To The Main Unit; Start-Up - LIVARNO LUX Z31999 Instrucciones De Montaje, De Uso Y De Seguridad

Mounting the solar cell

The solar cell
cell surface will be directed to the south. The enclosed bracket
sure the solar cell is mounted horizontally.
Mount the bracket
enclosed screws
(ø 6 mm) (see Fig. C).
Note: The enclosed mounting material is suitable for ordinary masonry
construction. Other wall substrates may require other fastening materi-
als. Seek specialist advice when in doubt.
After mounting, verify the solar cell
Then attach the solar cell as shown in Fig. C.
Next adjust the solar cell to face south.

Connecting the solar cell to the main unit

After mounting the two operating units (main unit
the connection cable so it is not subjected to mechanical stress. Use typical
installation material such as cable clamps or conduit to fasten the connec-
tion cable, to prevent damage to the insulation.
Connect the plug connector
and the solar cell (see Fig. D).

Start-up

Note:
Connect the main station
first time. The solar cell
motion detector
26 GB/IE
requires direct sunlight when possible. Ideally, the solar
5
of the solar cell
9
(4 x 30 mm) and the enclosed wall plugs
7
1
also works as a twilight sensor, while the
5
only responds to movement.
3
to a vertical wall using the
5
is fitted securely by the bracket
5
1
from the main unit connection cable
4
to the solar cell
5
will en-
9
8
and solar cell
5
before using for the
.
9
) run