Publicidad
Idiomas disponibles
Idiomas disponibles
1. Press and hold BIND button on RF Signal Pack for 5 seconds until multi-colored LED on RF Signal Pack flashes amber. All RF
receptacles that are not already bound to an RF Signal Pack will now flash green, noting ready to bind. Any RF receptacle already
bound to this RF Signal Pack will flash amber. Any RF receptacle out of range or bound to another RF Signal Pack will not change
state. If your RF receptacle is not flashing, reset to factory default state by holding the receptacle BIND button for approximately
15 seconds until the LED is a solid amber.
2. Press and hold BIND button on RF Receptacle for 2 seconds until LED on receptacle flashes amber, noting it is properly bound. If
it was previously bound to this RF Signal Pack (was flashing amber prior to holding BIND button for 2 seconds) it will unbind and
flash green.
3. Repeat for all RF receptacles in room network.
4. Return to original RF Signal Pack and press and hold BIND button for 5 seconds until flashing LED on RF Signal Pack turns off.
All RF receptacles on the same room network will stop flashing, indicating Binding is complete.
5. Test that binding has been successful by tapping the push button of the RF Signal Pack and confirming that the green LED on the
receptacles turns on and off.
The green LED on the receptacle is on when the outlet has power, and off when the outlet is switched off. The bind button on the
receptacle or the RF Signal Pack can be pressed to override the occupancy sensor and turn on the receptacle temporarily.
Contains FCC ID: X7J-A11072401 and IC: 8975A-A11072401
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
PROCEDURE FOR BINDING
OPERATING INSTRUCTIONS
2
Publicidad
