Cleaning And Maintenance - Ferm HDM1028 Traducción Del Manual Original

Setting Operating mode
d
Fig. E
t A D emolition hammer / Chisel
B Hammer drill
C D rill
t • T urn the drill selection switch (2) and the
hammer selection lever (3) to the required
position.
t
Hints for optimum use
• C lamp the workpiece. Use a clamping device
or
for small workpieces.
• F irmly hold the machine by the grip.
ring the • S et the operating mode.
• S witch on the machine.
• D o not apply too much pressure on the
dust machine. Let the machine do the work.
• S witch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.
m the
5. CLEANING AND
MAINTENANCE
aft of
ctor
llector Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia
etc. Chemicals such as these will damage the
synthetic components.
Checking and replacing the carbon brushes
/off Fig. A
The carbon brushes must be checked regularly.
n/off If the carbon brushes are worn, the machine will
start to run unevenly.
e
e below • R emove the carbon brush holders (8) using a
screwdriver.
HDM1028 Ma 1611-07.indd 7
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Only use the correct type of carbon
brushes.
• C lean the carbon brushes.
• I n case of wear, replace both carbon brushes
at the same time.
• M ount the carbon brush holders (8) using a
screwdriver.
• A fter mounting the new carbon brushes, let the
machine run at no load for 15 minutes.
Defects
The machine should be regularly inspected for
the following possible defects and repaired if
necessary.
• D amage to power cord.
• B roken on/off trigger assembly.
• S hort circuiting.
• D amaged moving parts.
Faults
Should a fault occur, e.g. after wear of a part,
please contact your seller or the service address
on the warranty card. Separate you find an
exploded view showing the parts that can be
ordered.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
7
23/11/16 16:35