Maintenance - Dimplex XLF50 Manual De Instrucciones

Maintenance

Remote Control Battery
Replacement
To replace the Battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or
CR2025) Battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area
 
WARNING: Disconnect power
and allow heater to cool before
attempting any maintenance or
cleaning to reduce the risk of
fire, electric shock or damage to
persons.
!
NOTE: The fireplace should
not be operated with an
accumulation of dust or dirt on
or in the unit, as this can cause
a build up of heat and eventual
damage. For this reason the
heater must be inspected
regularly, depending upon
conditions and at a minimum
yearly intervals.
www.dimplex.com
Partially Reflective Glass
Cleaning
The partially reflective glass is
cleaned in the factory during
the assembly operation. During
shipment, installation, handling,
etc., the partially reflective glass
may collect dust particles; these
can be removed by dusting lightly
with a clean dry cloth.
To remove fingerprints or other
marks, the partially reflective glass
can be cleaned with a damp cloth.
The partially reflective glass should
be completely dried with a lint
free cloth to prevent water spots.
To prevent scratching, do not use
abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean
painted surfaces of the fireplace.
Do not use abrasive cleaners.
Servicing
Except for installation and cleaning
described in this manual, an
authorized service representative
should perform any other servicing.
23