Warm House CMSF-1/0310 Instrucciones Importantes Manual De Funcionamiento página 6


This fireplace consists of 2 bulbs (E‐12, 40W) that illuminate a flame effect. The light bulbs need
to be replaced if you notice a dark section of the flame or when the flames lose clarity.

Warning ‐ Always disconnect from the power outlet before removing bulbs to reduce the risk of
fire, electric shock or damage to property.

Warning ‐ The bulb reaches high temperatures during operation. Allow it to cool down before
replacing it.

Access the bulb panel located on the rear panel of the fireplace (see figure below).

Access the bulb by removing the four screws located on the back panel.

Replace the bulb with a new one. Extra caution should be taken because the bulb can be hot.

Close the panel lid using screws.

Warning – Do not use fireplace without properly putting the lid back in place.
Cleaning & Maintenance

Disconnect from the power supply before attempting any maintenance or cleaning in order to
reduce the risk of fire, electric shock to persons or damage to property.

Warning ‐ Always disconnect from the power supply before cleaning fireplace.

For general cleaning, use a soft, clean duster. Never use abrasive cleaners. The glass viewing
screen should be cleaned thoroughly with a soft cloth. Do NOT use proprietary glass cleaners.
Technical Specification

Supply: 110‐120V, 60Hz

Rated Power: 1500W

Bulb: 2 x 40W E12
6